Odroid N2+ minikomputer z procesorem Amlogic S922X 4Gb + obudowa. Sprawny technicznie bez wad ukrytych. Sprzedaję z powodu zmiany koncepcji Smart domu
SBC Specification
Form FactorBoard Dimensions: 90mm x 90mm x 17mm
Heatsink Dimensions: 100mm x 91mm x 18.75mm
Weight: 200g including heatsink
ProcessorAmlogic S922X Processor (12nm fab)
Quad-core Cortex-A73(up to 2.4Ghz) and Dual-core Cortex-A53 (up to 2Ghz)
ARMv8-A architecture with Neon and Crypto extensions
Mali-G52 GPU with 6 x Execution Engines (800Mhz)
MemoryDDR4 4GiB with 32-bit bus width
Data rate: 2640 MT/s (PC4-21333 grade)
1.2Volt low power design
Storage1 x eMMC connector (8G, 16G, 32G, 64G, 128G and 256G are available)
1 x microSD slot (DS/HS modes up to UHS-I SDR104)
Networking1 x GbE LAN ports (RJ45, supports 10/100/1000 Mbps)
– Realtek RTL8211F (Ethernet transceiver)
– LED indicators
* Green LED: Flashing by data traffics at 100Mbps connection
* Amber LED: Flashing by data traffics at 1000Mbps connection
Optional WiFi USB adapters
Video1 x HDMI 2.0 (up to 4K@60Hz with HDR, CEC, EDID)
1 x Composite video (3.5mm jack)
Audio1 x Stereo Audio line-out (3.5mm jack)
1 x HDMI digital output
1 x Optional SPDIF optical output
External I/O4 x USB 3.0 Host ports (shares one single root hub)
1 x USB 2.0 OTG port for Host or Device mode. (No power input)
1 x Debug serial console (UART)
1 x Peripheral Expansion Header (40-pin, 2.54mm pitch)
– 2 x DC 5V, 2 x DC 3.3V, 1 x DC 1.8V, 8 x GND
– 1 x SPI
– 1 x UART
– 2 x I2C
– 25 x GPIO (Max)
– 2 x ADC input (10bit, 1.8V Max)
– All 3.3V I/O signal level except for ADC input at max 1.8Volt.
Other featuresOn board RTC(Real Time Clock) IC to keep date and time. A CR2032 coin battery holder was replaced with the 2-pin 1.25mm pitch connector.
No battery is included in the board.
Please purchase the very common bare CR2032 cell from your local store.
You can keep the RTC time up to several years with a 200mAh CR2032 battery.
8MiB SPI Flash for boot manager
IR receiver for remote controller
Built with a large passive heatsink
System LEDS Indicators:
– Red (PWR) – Solid light when DC power is connected
– Blue (ALIVE) – Flashing like heartbeat while Kernel is running.
Active Cooling Fan Connector (5V 2-pin)
– Connector (2-pin, 1.25mm pitch)
Power1 x DC jack : outer (negative) diameter 5.5mm, inner(positive) diameter 2.1mm
DC 7.5V ~ 18V (up to 25W) *** 7.5V ~ 16V from 2022 production (LOT number starts with EL22)
– DC 12V/2A power adaptor is recommended
Power consumption:
– IDLE : ≃ 2.2W (Performance governor)
– CPU Stress : ≃ 5.9W (@2016/2208MHz), 6.2W (@2016/2400MHz)
– Power-off : ≃ 0.2W