I am selling my Rode NT2-A. Hardly ever used.
The NT2-A microphone is the heir to the legendary RØDE NT2 microphone. It is equipped with a professional 1-inch capsule with switchable polar patterns, a PAD attenuator and a high-pass filter switch located directly on the microphone housing.
The heart of the NT2-A is the original Australian HF-1 double capsule. Both in terms of bandwidth and response to transients, it has been adapted to the requirements of microphones used in modern recording techniques, while providing a gentle sound typical of microphones from the 1950s and 1960s. This makes the NT2-A one of the most universal microphones available on the market.
Switches located on the microphone housing allow you to select one of three polar patterns: omnidirectional, figure-eight or cardioid. A 3-position filter switch allows you to select a flat frequency response or activate a high-pass filter with a cutoff frequency of 40 or 80 Hz. The internal PAD can be set to 0 dB, -5 dB or -10 dB. The NT2-A comes with an M2 mount for tripod mounting and a soft case.
Main features:
Original, 1-inch, Australian HF-1 capsule containing two gold-plated diaphragms, 5 um thick, Polar
pattern switchable from the microphone: omnidirectional, figure-eight and cardioid,
3-position filter switch allowing you to set: flat response pattern or high-pass filtering with a cut-off frequency of 40 or 80 Hz,
3-position Pad attenuator: 0, -5, -10 dB,
Output systems ensuring an extremely low level of self-noise,
Wide dynamic range,
Solid, impact-resistant metal mesh protecting the capsule,
Satin-coated housing nickel,
Internal, flexible capsule suspension,
Includes flexible holder, pop-filter, high-quality microphone cable,
Designed and manufactured in Sydney, Australia.
Accessories:
Handle with flexible suspension,
Pop-filter,
High-quality XLR – XLR microphone cable,
Microphone case.
Specification:
Power supply: Standard P48 Phantom power supply, compatible with 44 – 52 V voltage generated on pins 2 and 3 of the XLR connector,
Load impedance: compatible with loads not less than 1 kOhm. In the case of smaller loads, the output signal level will be reduced. The pin layout is as follows: Pin 1 - ground, Pin 2 - hot, Pin 3 - cold,
Cartridge: 1-inch (25 mm), double, externally polarized,
Polarity characteristics: Omnidirectional, figure-eight, cardioid,
Frequency response: 20 Hz - 20 kHz,
Output impedance: 200 Ohm,
Signal-to-noise ratio [IEC651]: 87 dB, 1 kHz, 1 Pa [IEC651, IEC268-15],
Equivalent noise level: 7 dBA SPL [IEC651, IEC268-15],
Max. SPL: 147 dB [THD 1% for a 1 kOhm load], 157 dB [THD 1% for a 1 kOhm load] - with Pad turned on -10 dB,
Sensitivity: -36 dB, 1 V/Pa [16 mV at 94 dB SPL] +/-2 dB,
Dynamics [DIN IEC651]: 140 dBA [IEC268-15],
Power supply: Phantom 48 V,
Current consumption: 6 mA,
Max. output level: +16 dBu [THD 1%, 1 kOhm] ,
Weight with packaging: 860 g,
Dimensions: 209 x 55 x 55 mm.